Server Machine shows all connected Parties, Connected Parties can not see each other.
--I am connecting to machine on my network with my Lan IP. I can see the Host Aircraft. Just not any participants. nor can they see me.
My Hub does not show up on the hubs list on machines other than the server machine, which is not my flight machine.
I am sure this is a simple fix maybe a port or something like that.
2 issues
Re: 2 issues
Hi Steve,
You should have two ports configured for port forwarding on your router. For example, 6112 goes to your simulator IP address, while 6113 goes to your JoinFS server IP address. Configure the JoinFS settings correspondingly. Your fellow pilots would then be connecting to 6113.
Peter
You should have two ports configured for port forwarding on your router. For example, 6112 goes to your simulator IP address, while 6113 goes to your JoinFS server IP address. Configure the JoinFS settings correspondingly. Your fellow pilots would then be connecting to 6113.
Peter
Re: 2 issues
Hi Steve
Open ports are fine but not what Peter told you to do. You have to setup two port forwards in your router. Read this forum entry to understand what that means:
http://pmem.uk/joinfs/forum/viewtopic.p ... 4008#p4005
Good luck
Geronimo
Open ports are fine but not what Peter told you to do. You have to setup two port forwards in your router. Read this forum entry to understand what that means:
http://pmem.uk/joinfs/forum/viewtopic.p ... 4008#p4005
Good luck
Geronimo