Prepar3d V4 compatibility

[mutley]

Hi Peter,

I have seen an unsubstantiated report that JoinFS is already compatible with P3Dv4, can you confirm this?

Cheers.
Joe

[Peter]

Hi Joe,

I've made no attempt to check on its compatibility. However, if the developers are providing SimConnect backward compatibility themselves then there is not reason why it shouldn't work. It's just a case of try it and see. I would be surprised if there are any major issues but you never know.

Peter

[HC447LO*SP*David]

What about X Plane 11please ?

[Peter]

What about X Plane 11please ?

Perhaps later this year. I have X-Plane 10 now so at least I have something to work with, or at least see if it will be possible.

Peter

[Ron Attwood]

Works perfectly with V4.

[Peter]

Thanks, Ron.

Peter

[fsgg]

But we did some flying with 3 x FSX, 2 x P3Dv3 and 1 P3Dv4 pilot in one session and the FSX and P3Dv3 pilots saw everyone including the P3Dv4 pilot, but the P3Dv4 pilot saw that he was connected ( all green) but didn't saw the other planes on the airport.
Joop

[Peter]

Could be scenery differences. Did they see them once everyone was in the air?

Peter

[CPC900]

Peter, in another thread I mentioned the same thing; not being able to see the FSX pilot in P3D V4 with JoinFS.
We were both using the same add ons, essentially. That would be:

Me:
P3D V4
Flysimware MU2
Orbx Global/Vector/PILOTS! 2010 Mesh
Active Sky 2016

Him:
FSX-SE
Flysimware MU2
Orbx Global/Vector/PILOTS! 2010 Mesh
Active Sky 2016

Bruce

[Peter]

Hi Bruce,

Did you see him in the user list and/or the aircraft list?
Any unusual messages in the monitor view?
Did you try checking when you were both near each other in the air?

Peter